Special forging roll manipulator
LASCO manipulator gripper fitted with compensating member to balance out changes in billet lengths sense of direction (synchronized or reverse rotation) can be changed via direct drives
Optional roller temperature control (heating/cooling)
The cross wedge roll is used for pre- and finish-forming (material distribution) of round forging parts, stepped as well as hollow shafts. Heated round bars are rolled between two synchronized rollers fitted with tools.
Roller gap adjustable symmetrically to rolling plane
Sense of direction (synchronized or reverse rotation) can be changed via direct drives
Optional roller temperature control (heating/cooling)
Optional roller change manipulator
No fly wheel, clutch or brake necessary due to torque motor drive
High dynamics and control accuracy through drive via two electronically synchronized servo torque motors
Electronic roller synchronization optimizes dimensioning of the roller gap and allows roller gap adjustments during the rolling process
Considerable material savings optimized work-piece surfaces also with non-ferrous metals
Patented roller change system
Roller diameters from 350 mm to 1,400 mm (QKW) and 460 mm to 930 mm (RCW)
l >High dynamics and control accuracy through drive via two electronically synchronized servo torque motors
Electronic roller synchronization optimizes dimensioning of the roller gap and allows roller gap adjustments during the rolling process
Considerable material savings optimized work-piece surfaces also with non-ferrous metals
Patented roller change system
